Differences

This shows you the differences between two versions of the page.

--- start:knowledge:3dprinting:postprocessing [2025/04/19 21:08] – florian
+++ start:knowledge:3dprinting:postprocessing [2025/04/19 21:26] (current) – florian
@@ Line 1: / Line 1: @@
 [[start:knowledge:personal|<< Back]]
+====== Post Processing ======
+[[https://www.youtube.com/watch?v=ZTE9bJyUO_8&ab_channel=3DPrintedProps|Finishing 3D Prints: How to Sand, Fill and Prime 3D Printed Parts]]\\
+[[https://www.youtube.com/watch?v=BDjVEgaV5jY&ab_channel=Darkwingdad|3D printing hack - Finishing 3D prints with less sanding required | How to sand 3D prints fast!]]\\
+[[https://www.youtube.com/watch?v=OBQ2lVl3Qnc&t=310s&ab_channel=JakeGrim|My Secret To No More 3D Printed Layer Lines]]\\
+[[https://www.youtube.com/watch?v=ADXFMJ4H5Io&ab_channel=DoasIDo|Hoe laaglijnen op 3D-afdrukken te verbergen. Gladde 3D-geprinte PLA-onderdelen]]\\
+[[https://www.youtube.com/watch?v=x1DYbKCGoUc&ab_channel=EvoLutionXStudios|Post processing resin prints: Remove support marks, holes, gaps, recrate texture and glueing]]\\
+  - Met ontspaaner langs de randen gaan
+  - Schuren met de hand
+  - Mix van aceton en houtvuller
+  - Opschuren
+  - Automotive primer er over
+  - Schilderen
+Bij een geschuurd model kan je vaseline gebruiken om de kleur terug te brengen\\

Brain II