Differences

This shows you the differences between two versions of the page.

--- start:knowledge:3dprinting:slicing [2025/04/11 12:17] – created florian
+++ start:knowledge:3dprinting:slicing [2025/05/02 17:14] (current) – florian
@@ Line 1: / Line 1: @@
-[[start:knowledge|<< Back]]
+[[start:knowledge:personal|<< Back]]
 ====== Slicing ======
+[[https://www.reddit.com/r/BambuLab/comments/1768te3/is_bambu_lab_pla_support_worth_it/|Only use contact layer for support material]]\\
+[[https://www.youtube.com/watch?v=QxT8uAMeBGo&t=250s&ab_channel=Planet3DP|Ironing Feature in Bambu Studio: Detailed Comparisons Revealed]]\\
+[[https://www.youtube.com/watch?v=BmgS1UvcjrU|Half your 3d printing time]]\\
+Look out for thin walls! Make sure there are no holes on places whre you would otherwise have a thin wall.\\

Brain II