[[start:knowledge:personal|<< Back]]


====== Slicing ======

[[https://www.reddit.com/r/BambuLab/comments/1768te3/is_bambu_lab_pla_support_worth_it/|Only use contact layer for support material]]\\
[[https://www.youtube.com/watch?v=QxT8uAMeBGo&t=250s&ab_channel=Planet3DP|Ironing Feature in Bambu Studio: Detailed Comparisons Revealed]]\\
[[https://www.youtube.com/watch?v=BmgS1UvcjrU|Half your 3d printing time]]\\

Look out for thin walls! Make sure there are no holes on places whre you would otherwise have a thin wall.\\